ICNMM Slides
Here are my slides for presentation at ICNMM. I’m linking them here to facilitate discussion at NRG later today, if desired.
.pptx version – ICNMM2016 Presentation Slides
.pdf version – ICNMM2016 Presentation Slides
Similar Posts
Fabricating 0.5 um Channels in Microscope Slides for Staph Invasion Assays
ByAlecSummary After success with the development and execution of the μSiM-CA (Canalicular Array; see Masters et al., Nanomedicine: Nanotechnology, Biology, and Medicine 2019), Jim wanted to develop a platform to answer some more biophysics focused questions. In order to facilitate these studies, the platform would ideally be configured to allow for live imaging of staph…
A3G diffusion tests through pnc-Si
This is a summary of diffusion experiments with A3G that were conducted during the week of 5/10/2010-5/14/2010. The HMM structure of A3G is a large protein multimer held together with RNA. Since the ultimate goal of this project is to develop a screening assay for HIV drugs, a successful experiment is one that will show…
Sepcon-transwell Discoloration IV (2D vs 3D)
Again a repeat, with comparison to the 2D format. To me, it looks like its again a repeat of what we saw in the previous trials. The sample with both intact slits has slightly higher discoloration than the others and also the pattern seems to originate from the slits (this is what we are looking…
Permeance/Porosity and Burst Pressure
Permeance of a sample was first calculated by taking a TEM image of the membrane and extracting pore size histograms. The flow rate through each pore can be calculated and then summed to determine the flow rate through the sample. The flow rate is then normalized by the pressure and surface area to calculate permeance…
Low temp/ramp rate anneal
Last week I showed some interesting images on the effects of annealing at a low temperature (700 C) with the susceptor. Below are images from a wafer that was annealed at 700 C with a ramp rate of 10 C/s outside the susceptor. Immediately following RTP, I saw that the outer part of the wafer…
Labsmith microfluidic pressure sensor (updated)
I’ve been trying to do separations with the NPN 5-slot filters by driving the solution with a syringe pump. This type of separation is required by INT for use in their cartridge. Unfortunately, at most concentrations, solutions with fluorospheres tend to stop flowing after 20-30 µL of filtrate is collected. We believe their is a…